Hvac Company in Universal City, TX

A new system should be sized to your home, not guessed. We begin with a load calculation that considers square footage, insulation, window exposure, and duct layout, then recommend equipment with the SEER2 and AFUE ratings that fit your comfort goals and budget. Installation follows a careful sequence. Technicians set the condenser on a level pad, braze and pressure-test the line set, pull a deep vacuum before releasing refrigerant, and confirm gas connections and venting are leak-free. You receive a post-job walkthrough covering thermostat settings, filter location, and warranty registration.

Routine maintenance catches small problems early. During a tune-up, we clean the evaporator and condenser coils, measure refrigerant pressures and temperature split, tighten electrical terminals, and test capacitors and contactors for signs of wear. On the heating side, we inspect burners, flame sensors, and the heat exchanger for cracks, and confirm carbon monoxide readings stay within safe limits. Spring and fall visits help Universal City homeowners prepare for summer heat and winter cold fronts before peak demand hits.

Dust, pet dander, and construction debris collect inside supply and return ducts over time. Our process uses negative-pressure collection equipment paired with rotary brushes and air whips to loosen buildup and pull it out of the system rather than into your living space. Before cleaning, we cover floors and furniture near registers and inspect duct joints for gaps or damaged insulation. Afterward, we show you before-and-after conditions and point out any leaks or sagging runs that may be wasting conditioned air.